![]() The easiest solution is to use a microphone arm stand. If the noise goes away, then you know what caused it. Try holding the Snowball in your hand and using it. The table can carry the noise to your mic too. The noise isn’t necessarily transferred by air, though. The fans create a buzzing or humming noise that sounds a lot like static crackling on your Blue Snowball. ![]() ![]() If you notice that the static noise goes away when you aren’t playing any games, the static noise could be caused by your computer fans. Last update on / Affiliate links / Images from Amazon Product Advertising APIįor more information, check out my article about how to stop a Blue Snowball from picking up computer fans The Blue Snowball Picks Up Vibrations From Computer Fans Plus, the cable is shielded with tinned copper for even better noise reduction. It’s USB 2.0, so it’ll be compatible with the Snowball. The Tripp Lite USB 2.0 Cable with Ferrite Chokes from is exactly what you need. The chokes protect the cable from electronic noise. Shielding on cables creates a Faraday cage that protects the signal from electrical noise and EM radiation.Īlternatively, get a USB cable with ferrite beads. If that doesn’t help, you should try a higher-quality USB cable with better shielding. The easiest fix is to move your USB cable as far away from the power cables as possible. Since you’re using the USB cable for audio, it’s extremely sensitive to static. If the cable from your Blue Snowball is near a power cord, like the one going into your monitor or power supply, it can pick up static noise. USB cables are thin, so they’re prone to interference. The Blue Snowball USB Cable Picks Up Static Noise You should return the microphone in that case.įor more information, check out how to make a Blue Snowball louder. If the noise only goes away in omnidirectional mode, there’s an issue with the electronics inside the microphone. If the static noise goes away, then the cause was most likely ambient noise. If your mic is in cardioid now, try to use the -10 dB mode instead. The omnidirectional mode picks up too much noise surrounding the mic and can result in static noise. If the microphone is for voice calls, you should use cardioid or cardioid with -10 dB pad. 1 is for cardioid, 2 is for cardioid with -10 dB pad, and 3 is for omnidirectional. The modes can be changed by adjusting the slider on the back of the microphone. Cardioid with -10 dB pad: Same as cardioid, but less microphone gain for reduced ambient noise.Omnidirectional: Records everything surrounding the microphone.Cardioid: Picks up all sound in front of the microphone.In case you didn’t know already, Blue Snowball comes with three distinct pickup settings : There Is an Issue With the Blue Snowball Microphone Mode If the cable is only partially plugged into the mic or computer, it can cause static noise. Important Note: Ensure that the USB cable is all the way in on both sides. That’s where the motherboard USB ports are. You can do that by taking the USB cable and plugging it into the back of the computer. It’s best to skip all intermediary connectors and plug the Blue Snowball directly into the motherboard. They also connect to your motherboard via an internal cable. In a nutshell, they’re just fancier USB hubs. You might think that the USB ports on the front of your PC case are better, but they aren’t. That’s because a USB hub can cause power and bandwidth issues. USB hubs are only good for storage devices. If you plug your Blue Snowball into a USB hub, it can cause a lot of problems. Blue Snowball Is Plugged Into a Front USB Port or Hub It’s not a perfect solution, which I’ll explain later, but it’s worth a shot if you don’t have USB 2.0 on your computer. If all ports look indistinguishable on your computer, refer to the motherboard manual.Īn alternative is to use a USB 2.0 hub. USB 3.0 and 3.1 are blue, whereas older generations have black plastic. You can usually tell the difference by looking at the plastic tab inside the port. The easiest solution is to just use a USB 1.0 or 2.0 port instead of 3.0 (or newer). So, it’s easy to make the mistake of plugging the Blue Snowball into it. If you have a newer computer or PC case, you probably have several USB 3.0 ports. Since USB 3.0 is backward compatible with older standards, you’d assume that it’ll work without any problems. Surprisingly, Blue Snowball has never bothered making the mic compatible with USB 3.0. The USB 3.0 standard was introduced back in 2008. ![]() The Blue Snowball Is Plugged Into a USB 3.0 Port
0 Comments
Leave a Reply. |